A seam on the back wall a bathtub has will often be seen where the tub's flange meets its backer board. This area is where caulk can be applied to seal it. However, some areas are not able to be sealed and may need to be patched. Make sure you follow all the correct procedures when installing a new tub surround.
The tub surround should be level at the back. Before you start installing the tub surround, you'll need to remove the old one. This can be done with a pry bar, or a Hammer. You should also wear protective gear.
Depending on your needs, you can install a tub surround over wood, concrete or tile. There are many styles and colors available for these surrounds. These surrounds are most commonly made of acrylic or plastic panels. Each type has its specific installation instructions. Some kits include only one back panel, others include two. To keep your costs down, consider purchasing a single-piece surround.
Once you've removed the old surround, you'll need to remove the corner panels. Measure the new surround to determine the size. It's important to have the right adhesive to ensure it sticks well. The adhesive will need to be applied to several sections at once so it is best to allow enough time for it to dry.
When you're ready for the adhesive to go on, mark the left- and right-sides of your wall along with the top and base of the surround. This will serve as a visual reference point to help you apply the adhesive. Cut the adhesive lines exactly. Masking tape can be used to make the lines more visible.
Next, place your surround against the wall. Then adjust the back until it is flush. The back should be flat against the drywall. If the back section isn't level, you can add additional adhesive to close the gap. After applying the adhesive, you'll need to let it dry for at least 24 hours.
Now it's time to put the tub surround back wall in place. This is the most straightforward part. However, it's a good idea that a friend holds it in place to help it stay steady. Alternatively, you can set a level across the surface and use it to guide the installation.
You will attach the end flanges on the studs. Fasteners should not be driven through predrilled holes with a large diameter. A few 2x4 nails can be added for additional support. These should be attached to the drywall but not directly to the wall framing.
Before you can start tiling, it is necessary to apply the correct vapor barrier. A vapor barrier, which is thick plastic sheeting, protects the wall against moisture. You will also need primer and paint. There are many types and brands of glue. Make sure you check the manufacturer's instructions for further information.
FAQ
Do I need an architect or builder to help me?
You might find it easier to hire someone to do your home renovations. An architect or builder is a good option if you plan to buy a new house.
What are my considerations when purchasing a new house?
You need to ensure you have enough funds available to cover closing costs before you buy a home. Refinancing your mortgage might be an option if you don’t have enough cash.
What can I do to save money on my home's renovation?
It is possible to save money by doing the work yourself. You could, for example, try to reduce the number of people involved in the renovation. Another option is to try to lower the cost of the materials you use in your renovations.
How Much Does It Cost To Renovate A House?
Cost of renovations depends on the material used, how large the job is and how complex it is. Certain materials, such as wood, require special tools like drills and saws. Others like steel don't. The cost of renovations will vary depending on whether your contractor does all the work or you do it yourself.
Home improvements can cost anywhere from $1,000 to $10,000 on average. If you are looking to hire professionals, expect to pay between $5,000 and $25,000. The total cost of hiring professionals could be anywhere from $5,000 to $25,000. If you choose to complete the task yourself, it could run up to $100,000.
There are many factors that influence the final cost of renovations. These include the material used (e.g. You can choose between brick or concrete, and the size of your project as well. When estimating the total cost for renovation, it is important to keep these factors in your mind.
Statistics
- On jumbo loans of more than $636,150, you'll be able to borrow up to 80% of the home's completed value. (kiplinger.com)
- A final payment of, say, 5% to 10% will be due when the space is livable and usable (your contract probably will say "substantial completion"). (kiplinger.com)
- They'll usually lend up to 90% of your home's "as-completed" value, but no more than $424,100 in most locales or $636,150 in high-cost areas. (kiplinger.com)
- ‘The potential added value of a loft conversion, which could create an extra bedroom and ensuite, could be as much as 20 per cent and 15 per cent for a garage conversion.' (realhomes.com)
- The average fixed rate for a home-equity loan was recently 5.27%, and the average variable rate for a HELOC was 5.49%, according to Bankrate.com. (kiplinger.com)
External Links
How To
5 Things to Know Before You Start Your Home Renovation
-
This is a big undertaking. You will need help if you are going to embark on a major home improvement project such as renovating your bathroom, kitchen, or building a new house. You might reconsider if you're not confident enough to handle such a huge task on your own. It can take up your time and cost you money. You won't reap the benefits. Instead, hire someone who has experience in this field to assist you. You'll be able to save a lot of time and stress while still having a lovely space to call your own.
-
What amount should I spend on a renovation project? This one may seem obvious, however spending too much on renovation projects could make matters worse. The reason is because you'll probably find yourself having to pay back most of the costs at the end of the day. If you have a budget in place, stick with it. A lack of a budget could mean that you end up spending a fortune and getting nothing in return.
-
Do I hire professionals or do I need to DIY? - There's no right and wrong answer. We recommend hiring professional tradespeople, however, if you're able to afford them. Their advice will be invaluable in helping you decide how to proceed. For example, they'll be able install the plumbing correctly, ensure that everything is done safely, and provide you with a warranty when they finish their work. On the flip side, DIY projects usually involve lots of trial and error, which means you'll have to learn a lot of lessons the hard way. Additionally, you will have to deal all manner of problems that can arise along the way.
-
Can I afford it - Don't underestimate what a renovation will cost. Even if the project seems manageable, it could prove costly and you will need to borrow money. You should also consider the cost of selling your property if you plan to move soon after the renovations are completed.
-
Which place should I start? - When it comes to choosing where to start, there's no right or wrong place. We recommend that you pick something that you are passionate about. That way, you'll be motivated to keep going, and you'll be less likely to procrastinate. Also, avoid places that are difficult to maintain. For instance, you shouldn't attempt to redecorate your living room if you're constantly dealing with dust and dirt.